I-float Float Switch. Canyonland Worms. Aquaponics. Solexx XP, per linear foot - Solexx Panels. BSF bucket composter v2.1 » Black Soldier Fly Blog. Sharing Knowlege... Feeding Nations. An Improvised PVC Bulkhead Fitting for Liquid Storage Tanks. An Improvised PVC Bulkhead Fitting for Liquid Storage Tanks RuggedCompatible with and Inert to Most ChemicalsImpervious to WeatherMade from Common HardwareVery Inexpensive A "bulkhead fitting" is an unusual item of plumbing designed to pass a connection through the sealed wall of a vessel.
While there are a lot of household and industrial applications for them, you won't find bulkhead fittings at Home Depot. Speciality sources on the Web want $10 or $20 for what should cost pennies. I will show you below how you can easily and inexpensively improvise PVC bulkhead fittings from common parts from the hardware store. This example shows the construction of a 1-1/2" PVC pipe bulkhead fitting, which will be installed on the side of a 44-gallon vessel. The essential item in constructing a bulkhead fitting is a male-female pair of straight-threaded adapters, which can tighten to form a clamp on both sides of the vessel wall.
Here are the finished components, ready to be assembled. Making The 20 mm Siphon. Since I am making two sets of siphon for Abu Dhabi, its best I use this opportunity to document it in detail so that it can be a reference for those that want to make it.This post will be in parts.Making Bell and StrainerMaking the Stand PipeMaking Siphon OutletsThe InstallationMaking Bell and StrainerThis mini siphon make use of 50mm/2" PVC bell with end cap and 82mm/3" uPVC for the strainer with vent cap for cosmetic purpose.
Above are made for 12" Growbed and firstly the 82mm uPVC need to be cut to about 11", you may cut it longer depends on how you are installing yours. The Vent cap take up that additional inch to make the growbed 12 inches.Before cutting I normally use an A4 paper wrap around the pipe to ensure square cut, so use an A4 paper mark the necessary lines then cut the pipe to length. There you go, I make two since they asked for two. I use hacksaw blade to cut, initially make a trace cut around then cut it deeper. On the ends its easier to use a snip for cutting it. DIY Swirl Filter for Aquaponics. A swirl filter or solids filter is occasionally used in aquaponics to remove particles of fine fish waste.
Suspended matter in the form of fish poop, floating debris, food particles are removed to clarify the water that flows back to the fish tank. Improved clarity of water aids fish health. The Davoponic DIY Swirl Filter It also stops clogging the plant roots in a floating raft (DWC) aquaponics system and aids in the ability of the plants to absorb oxygen and dissolved nutrients. In a conventional aquaponics system, your growbeds are in a way – your swirl filter. Compost worms in the grow bed further help mineralise that fish waste and reduce the load that a basic system can handle. swirl filter laundry basket But sometimes – depending on fish stocking densities and on what species of fish is used in an aquaponics system – a swirl filter is a good idea to reduce the amount of solids in circulation. DIY Swirl Filter. Aquaponic Gardening Rules of Thumb - Aquaponic Gardening. Urban Farm Fanatic.
Aquaponics Gardening. Arizona Aquaponics - Aquaponic Gardening.