Bella. Butterfly - Fluttering Model to Download and Make. Become a Member for free access to all the models in the showcase. See the Membership page for more details. Already a Member? Log in Here The Fluttering Butterfly is a pendulum powered model to download, print out and make. Any slight movement of the model make the wings tremble and flap. Members can download the model at the link for free. The finished model. Fold the bottom of the pendulum up and glue it into place. Fold the pendulum in half and glue it at ninety degrees. Glue the paper hinge into place on the grey area. Glue the two linkages to the pendulum. You'll need four coins of approx. 25mm diameters. Fold the ends round and glue them down to make triangular sections. Repeat the process with the front and back of the box.
Glue the front, back and sides to the box base as shown. Fold the box up and glue it together. Fold up the flaps from the base and glue it to the inside of the box. Glue the paper hinge to the box. Fold up the wing stand. Glue on the paper hinges. Rate this post: Free. Add to Cart to download this kit for free ! Download and make this Smart-Phone Passive Speaker for free! This project is also available on the Instructables website. There are two designs of base for this model. The base you choose depends on the type of phone you use. If your phone has a loudspeaker along its bottom edge use the iPhone base. Print out the parts of the base that you are using onto thin coloured card. The horn is the same for both base designs. Fold over the end tabs to make a triangular section tube on each of the eight horn pieces. Pair up the horn pieces and glue together the first tab as shown.
Glue the pieces together by the first tab in this alternating pattern. Roll round and glue down the remaining first tab to make a tube. Work your way round the second row of tabs gluing them down as accurately as possible. Work your way to the end of the horn gluing one row of tabs at a time taking care to keep everything lined up accurately. Glue the horn end into place. Stickman to download and make. Become a Member for free access to this and other files on the site. See the Membership page for more details. Already a Member? Log in Here An articulated, posable stickman figure to download and make. Members can download the file for free, non-members can download the file for a small fee. These next few steps are for the thighs / upper arms. Notice the valley fold. Complete the piece by folding it round and gluing it closed. Now to make the lower legs and forearms. Glue the top cap into place as shown above. Glue the remaining three tabs on the top cap and fold it round and fit it into place.
The completed arms and legs pieces. Fold the body over to make a diagonal piece as with the arms and legs. Then fold the box closed. Fold the end tab over and glue it into place. Glue the head inner into the head using the grey areas for alignment. Glue the other half of the head into place. Glue the shoulder attachment points to the body using the grey area for alignment. Pose your stickman!
The Rolling Reels Circus /Il Circo dei Rocchetti Rotolanti | As Tom Mitchell said:This is the perfect thing to have at work for when I need a “mental health moment”. Released year: 2005 Thank you michael42er! Embedded by paperpinoYouTube Direkt.