Resources – YS-X6 « MultiRotor. YS-X6 Installation Video Important: 1. Please note that when connecting the ESC’s all red wires must be removed as the system is powered by its own BEC. 2. We recommend that any Gimbal servos rather be powered from a separate UBEC (Universal Battery Eliminator Circuit). 3. We recommend that you only use the Android GCS to change and update settings. 4. To use backlanding, the YS-X6/X4 needs to know where you armed the motors. It can only do this once it has picked up enough satellites.
ESC Setting – Important Please read this post ESC Settings Steadi470 Gimbal Calibration The best way to do the YS-X6 setup is as follows: 1. 5.1 Check Data connected 5.2 Channel Alignment 5.3 Ch5/Ch6 setup check 5.4 Set Aircraft Type, Cell Number and Magnetic Declination (if negative then enter positive value and if positive then enter negative value) 5.5 ESC stroke (Throttle) Calibration. 5.6 Check Install Direction of IMU/GPS 6. ESC/Throttle Calibration Then its done. Compass Calibration 1. 433Mhz 3DR on Ground. Zero UAV YS-X6 [Owners Thread] *Autopilot system for multirotors* RC Groups - View Single Post - YS-X6 Known bugs/Feature Request *Unofficial* I have posted this previously, and I do think it is important, so I am going to post it again.
The YS-X6 has a big drawdown on the batteries and I have seen it when I used fully charged 35C batteries, 2x2250 3S in Parallel and took off and I was within a minute getting vibration from my Tablet saying the voltage was low. As soon as I got into hover mode, the warning went away. Recommended ESC settings for Multirotors Brake: Off Battery Type: Ni-xx Cut Off Type: Soft-Cut Cut Off Voltage: Low Start Mode: Normal Timing Mode: Middle Music/Li-Po Cells:All Off Governor mode: Off - The brake settings should be OFF.
Please have a look at these posts made elsewhere Or here which reads “For multicopters we typically all use lipos. Rob. Multirotor.co.za/manuals/YS-X6 Tips.pdf. RC Groups - View Single Post - Zero UAV YS-X6 discussion Propriétaires et discussion.