WEISS Powder Applicator. Thermographers provide quality machines for over 30 years!! Sunraise developed our automated, stand alone powdering section specifically for the application of adhesive transfer industry.
Available in 12", 15", 20", 30", and 40" wide versions, each one features our exclusive molded cast aluminum vacuum head which focuses the vacuum precisely to the substrate surface allowing for a crisp, clean product every time. It can operate in-line with high production presses and our variable vacuum control which allows you to increase or decrease vacuum, accommodating powder as fine as 60 microns or as coarse as 200, allowing for a wide range of designs and effects.
With our legendary reputation for superior performance and reliability, you can bet adding a Sunraise Powdering Section to your operation will ensure years of productive service. With our legendary reputation for superior performance and reliability, you can bet adding a Sunraise Powdering Section to your operation will ensure years of productive service. Thermographers provide quality machines for over 30 years!! Textile heat transfer carousel. DST - Digital Screenprinting Technologies.
How to Make Dextrin Coated Paper for the Toner Transfer method of making PCBs « PaulWanamaker.wordpress.com. How to Make Dextrin Coated Paper for the Toner Transfer method of making PCBs Dextrin coated paper is the very best paper to use for the Toner Transfer method of creating Printer Circuit Boards (PCBs).
Why Dextrin Coated Paper it so good? The etching mask is printed on the dextrin coated side of the paper using a laser printerThe mask is then bonded to a PCB using a laminator (ideally) or an iron (ugh).Then the board with the paper still attached is placed in warm water.The dextrin coating immediately starts to dissolve and in 1 – 10 minutes it will just come off completely without any problems whatsoever. Note that Press-n-Peel takes just a minute to float off. This dextrin coated paper with the waterproofer will take longer – about 10 minutes. A Warning: You will probably not save much money (and definitely not time) making your own coated paper, particularly if you only make a small batch.
Materials needed: White heavy weight paper that has a smooth surface. Tips: Like this: Welcome To Anglo East. Laser printers use "toner" that is made up predominantly of pulverized plastic that can be made sticky with heat and pressure, so in theory we only would need to run a copper-clad board through the printer and we've accomplished the goal of applying a water-proof plastic based image on the copper-clad board, ready to etch.
However, in practice this won't work because the printing path is not straight and even if one was to somehow modify a printer so it could go straight through, the copper surface will ground-out the static charge necessary to make toner move where it needs to go. So we need another piece to the puzzle... a transfer paper to get the image out of the printer and be able to release it on command. Finding the right medium proved to be difficult item to find. The TRANSFER Medium: To solve the transfer paper problem we came up with the idea of using a special "no carrier" water-slide paper used mainly in the ceramics industry.
The APPLICATOR: The FOILS: .032" vs .064: Document & Commercial Presses. Dst-system-in-production-on-xeikon-roll-fed-printing-press.m4v.