multi-rotor
Get flash to fully experience Pearltrees
Minima - yet another quad copter build - eStuffz
Introduction Minima is my minimalistic quad copter build.
Tricopter V2.5
Ever since building the Tricopter V1 I’ve always tried to find ways to improve the construction. I always try new props, motors, esc’s, arm lengths, tail mechanism and such. Often I change stuff before each flight. Always in the quest to find the optimum setup for me.
ATROPOS: Fonera Quadrocopter. An insanely home-made UAV
Aimed by fritsl last post :) ... Atropos is a wifi operated quadrocopter system. It uses a Fonera 2201 with a custom compiled version of GNU/Linux OpenWRT.
BaronPilot Arduino based copilot autostabilizer with Nintendo Wii component (tricopter, quadcopter)
This is a program to stabilize a multicopter (copilot), runs on microcontroller like Arduino or Teensy++ and only a wii motion plus, no other electronics needed. These project started April, 2010. Supported are planes, tricopter, quadricopter (+ and x config), hexacopter (penta and coaxial).
Hello all, After some time flying with a 12"-arm quad-copters, I want to build a small one to fly in the office, and I also want to see how it feels to see a small quad fly. Videos: 1. 10" motor to motor configuration:
RC Groups - View Single Post - Building a palm size quad-copter & Introducing a new simple flight controller
Cut 2 of 14”, 4 of 6.125”, 4 of 8” carbon fiber square tubes Drill 7/64” holes 3/8” away from each ends of the cut carbon fiber tubes.
quadrotor
