PGA2500/2505: Digitally Controlled Mic Preamps.
Servo Control! Arduino Leonardo ATmega32u4 without headers ID: 883 - $22.50. USBtinyISP AVR Programmer Kit (USB SpokePOV Dongle) [v2.0] ID: 46 - $22.00. TI remote Pre chip. Ethernet Modules. Just Arrived our fantastic new Ethernet Module.
This compact easy to use Ethernet Module plugs directly onto your network for remote control and switching. No set-up or programming is required, the Ethernet Module is immediately detected on the network and each of the 24 I/O points can be monitored or switched. This Ethernet Module is ideal for remote monitoring and control, each of the I/O points can be monitored or switched from any point on the network, Internet access and control is also possible.
The device is automatically assigned an IP address when connected to the network. Any number of devices can be connected to the same network, with each location having a unique IP address. Our new Ethernet Module is ideal for remote control and monitoring over a network. Part Code: ETHERIO24 Features Technical Data. ARM projects. By Martin THOMAS Please: Before asking any questions by e-mail or in the forum make sure that you are using the latest version of the examples and/or tools.
Some problems have already been fixed. WinARM Readme. Emb4fun. Yet another GNU ARM toolchain. Ethernet Mini Board. Just arrived our fantastic new Ethernet Mini Board, easily connect your control system or microcontroller board to an ethernet network, with our compact, easy to use network board.
This board utilizes the new Microchip® ENC28J60 Stand-Alone Ethernet Controller IC featuring a host of features to handle most of the network protocol requirements. The board connects directly to most microcontrollers with a standard SPI interface with a transfer speed of up to 20MHz. The Microchip® ENC28J60 is fully compatible with the IEEE 802.3 specification for network communication protocol. The IC includes a number of packet filtering schemes to reduce the number of incoming packets and thus the overhead required in handling network communications. An internal DMA is included for fast data throughput and hardware assisted checksum calculations. THATDIP Preamp - THAT1570/5171 Digitally Controlled Mic Pre [PICS] Aphex remote (a great unit and not very expensive) It is a good unit, BUT $1299 seems a bit steep for me personally, compared to the DIY nature of the project it would control...
![THATDIP Preamp - THAT1570/5171 Digitally Controlled Mic Pre [PICS]](http://cdn.pearltrees.com/s/pic/th/that1570-digitally-controlled-73647344)
Then its protocol would need to be reverse-engineered, which assumes I'd have to obtain a unit somehow. =) Therefore I am interested in making my own version of DIY RCU for these preamps, then it would be a sub-$300-400 remote, much more affordable, with similar features, and a lot of time would be saved by just implementing my own protocol to suit what I have already coded for the front panel controller (picture below). I don't know availability of which additional PCB (MIDI, Remote, PSU, Metering, Compressor) would make this project more desirable for people to undertake. Also, there is a lot to think about in terms of how to interconnect everything (the logical part of it, i.e. what is master/slave at what level, etc.).
uALFAT - FAT file system IC ($15.76) : Saelig Online Store. NOTE: Not recommended for new designs.
Manufacturer suggests the ALFAT SoC Processor. ALFAT™, pronounced micro ALFAT, is a robust file system chipset. It allows you to read and write FAT file system files at a low price point. ScanaLogic2 Analyzer / Signal Generator ($99.00) : Saelig Online Store. ScanaLogic2 is an amazingly full-featured, compact, easy to use PC-based 4-channel logic analyzer and signal generator all in a single tiny, economical package.
ScanaLogic2 is not only a logic analyzer, but also a comprehensive digital signal generator - a complete lab tool, all in one compact box. ScanaLogic2 is a simple device to use, easily mastered by beginners and professionals. Additionally, ScanaLogic2 provides the ability to generate digital signals, while recording the response on other channels. Services. I2S Interface v3.1.pdf (application/pdf Object) FPGA Network Processing Solutions for Wireless Backhaul, GPON Line Card, and Enterprise Data Centers. The demands for dynamically managed packet-based processing continues to climb at unprecedented levels fueled by the explosion of open collaboration services, advancements in mobility and social networking, proliferation of smart devices, as well as unification of quality of experience (QoE) demands across service provider and enterprise segments.
Xilinx delivers a variety of Smarter Solutions expanding traffic control, prioritization and monitoring capabilities to the granularity of single packet, individual session or application. These solutions enable network equipment to inspect and manipulate packet headers and payload contents, and to dynamically apply sophisticated routing policies.
FPGA, CPLD, and EPP Solutions from Xilinx, Inc. Introduction to VLSI. Software and Design Tools. The ISE® Design Suite: The Industry-proven solution for Xilinx All Programmable devices including 7 series (and pre-7 series devices) and Zynq™-7000 All Programmable SoC is available in three editions: ISE Design Suite: Embedded Edition The ISE Design Suite: Embedded Edition includes Xilinx Platform Studio (XPS), Software Development Kit (SDK), large repository of plug and play IP including MicroBlaze™ Soft Processor and peripherals, and a complete RTL to bit stream design flow.
Embedded Edition provides the fundamental tools, technologies and familiar design flow to achieve optimal design results. XILINX USB/Parallel JTAG cables on Linux without windrvr. About When using XILINX JTAG software like Impact, Chipscope and XMD on Linux, the proprietary kernel module windrvr from Jungo is needed to access the parallel- or usb-cable.
As this module does not work with current linux kernel versions (> 2.6.18) a library was developed, which emulates the module in userspace and allows the tools to access the JTAG cable without the need for a proprietary kernel module. The library uses libusb to access USB devices and the ppdev interface to communicate with parallel cables. The parallel part currently only supports Parallel Cable III mode (and PCIV in PCIII compatibility mode) as the faster PCIV modes use another kernel module which is not emulated by this library. So you are limited to a 200kHz JTAG clock when using Parallel Cable IV with this software. Experimental support for FTDI 2232 based devices has been added. The library is called libusb-driver as it was developed to support the USB cable, but later extended to also support parallel cables.
Howto_install_ISE_on_SuSE.pdf (application/pdf Object) Spartan-6. Spartan-3E Starter Kit. The Spartan-3E High Volume Starter Kit gives designers instant access to the complete platform capabilities of the Spartan-3E family.
The Spartan®-3E FPGA Starter Kit is a complete development board solution giving designers instant access to the capabilities of the Spartan-3E family. Spartan-3E Starter Kit Design Examples. Home. Xapp1016.pdf (application/pdf Object) s3esk_picoblaze_dac_control.pdf (application/pdf Object) s3esk_picoblaze_amplifier_and_adc_control.pdf (application/pdf Object) M95640 datasheet pdf datenblatt - STMicroelectronics - 64Kbit and 32Kbit Serial SPI Bus EEPROM With High Speed Clock. M95512 datasheet, M95512 datasheets, M95512 datenblatt, M95512 manual, M95512 data sheets, M95512 pdf - ALLDATASHEET.COM.
M95512 datasheet pdf datenblatt - STMicroelectronics - 512Kbit Serial SPI Bus EEPROM With High Speed Clock. 512Kbit Serial SPI Bus EEPROM With High Speed Clock. ST10F269 ST10F280 ST10F2xx. St10 equivalent datasheet and application note, data sheet, circuit, pdf, cross reference, pinout. St10 equivalent datasheet and application note, data sheet, circuit, pdf, cross reference, pinout.
m25p32.pdf (application/pdf Object)