background preloader

Bender

Facebook Twitter

Tube_bending_machines/90_Deg_Bender_Manual.pdf. The Mittler Brothers Model 900, 90 degree one-shot hydraulic bender, is an excellent hydraulic bender for job-shops and race car builders alike. Featuring a 25 ton hydraulic cylinder which can be powered by either an air/hydraulic or electric/hydraulic pump, this bender has enough power for bending 2 inch x .120 inch wall DOM. Since the bender is powered with hydraulics (not included) and is self-contained, it does not need to be bolted down to a table or stand. The bender has a built in scale for making repeat bends, and with the optional digital readout, repeat bends can be made even easier. Rugged construction and ease of portability make this bender robust and flexible. Warranty: 1 year manufacturer's warranty Part #: 900-MBShips From: Factory shippedAvailability: Usually ships within 1-2 weeks. Www.vansantent.com/model_32_bender_instructions.pdf. Cebby's JD2 Model 3 Hydraulic Conversion.

Cebby's Homebrew Hydro Bender (JD2) - OFN Forums. It's a knock off of Jay K's writeup ( ) Anyway - here's how it looks now: Valve mounted up on top plate. I drilled and tapped the top plate 5/16-18 and used socket head bolts. I slipped a rubber washed under each mounting point also. Did a similar mount for the pump. I had to "customize" a wrench to tighten the fittings on the pump. Here's the valve with all the hoses hooked up: Here's a couple overall shots: I'm having a problem with the motor wiring. Here's a pic of the schematic. The folks over on PBB told me P1 for Ground, T5 for Neutral and T8 for Hot. Thanks! Offroad Fabrication Network. Tube_Bender. Pirate4x4.Com. I'm sure for some, when you first unpack your bender, youll be lost.

I dont blame you, it looks like some sort of medieval torture devise Itll have some very confusing instructions and list of calculations that might as well be written in some ancient language.So youll throw some tube in the thing, pull the handle, and Ohhhh YEahhhh, youve bent tube with your bare hands! (In my best Tim Allen voicearuh aruhh... arhhh) But now youve got a bent piece of tube, with no way to know where to start, or stop. Yes, there is another way to do it! You dont need some big computer program, a degree in math or even have to know more than just basic addition and subtraction. Here are some basic tools you should have. A good stand is very important too. Again, this is by no means the only way, but in my opinion the EASIEST way to START. Once you get that bent, take a look at how the tube looks.

*Remember, EVERYTHING from now on will be based on this mark * Its as simple as this. Pretty fool proof so far? Tube Bending Machinery, Pipe Benders, Tubing Notchers, Bead Rollers. HOMEBREW HYDRO BENDER SETUP.